Methane dissolution inside bulk or porous-medium-confined water at near-hydrate equilibrium conditions

In this study, we perform a series of mass-balance-type calculations, in order to estimate the minimum volume of liquid water required to dissolve completely a single methane gas bubble, located inside different types of domains that are near or under hydrate equilibrium pressure/temperature conditions. We examine the case of methane bubble dissolution in the bulk, along with the cases of methane bubble dissolution within simple/regular networks of pores, where all pores have the same size. In our calculations, we consider experimental values for the equilibrium solubilities of methane in water, along the hydrate-forming line, as well as, values obtained from predictive tools that are based on different thermodynamic models. The effect of aqueous NaCl solutions on the results is also investigated. As a result of the relatively low solubility of methane in water, large volumes of water are required for complete dissolution of a methane bubble.     

油-气-水三相流超声传感器持气率测量*

为探索油-气-水三相流持气率测量难题,该文开展了脉冲透射式超声传感器持气率测量动态实验研究。首先,利用超声传感器与光纤传感器组合,测取了油-气-水三相流中段塞流、混状流、泡状流的响应信号;其次,提取了超声脉冲信号的最大值序列来反映不同流型时超声传感器响应特性,同时,借助双头光纤传感器与相关测速法,计算得到了流体中气泡弦长序列;最后,结合流型与泡径信息,利用超声传感器测量了不同流型下持气率,并分析了不同流型持气率预测的误差来源,为其他油-气-水三相流持气率测量传感器设计提供了借鉴。     

Anti-wear beam effects on gas–solid hydrodynamics in a circulating fluidized bed

Anti-wear beams installed on water walls of circulating fluidized bed (CFB) boilers are one of the most effective ways to protect against water-wall erosion. Beam effects from, for example, beam size and superficial gas velocity were investigated on gas–solid hydrodynamics in a CFB test rig using CFD simulations and experimental methods. The downward flow of the wall layer solids is observed to be disrupted by the beam but is then restored some distance further downstream. When falling solids from the wall layer hit the anti-wear beam, the velocity of the falling solids decreases rapidly. A fraction of the solids accumulates on the beam. Below the beams, the falling solids have reduced velocities but upward-moving solids were observed on the wall. The effect of the beam increases with width and superficial gas velocity. Wear occurs mainly above the beam and its variation with width is different above to below the beam. There is an optimum width that, when combined with beam height, results in less erosion.     

Metabolomics techniques applied in the investigation of phenolic acids from the agro-industrial by-product of Carapa guianensis Aubl

Processing of Carapa guianensis seeds to obtain oil on an industrial scale generates a significant amount of by-product, approximately 66% w/w, which is called cake and is a potential source of biomolecules, including simple phenolic structures. For this reason, studies were carried out on the chemical profiles of hydrolyzed extract from this agro-industrial by-product through High Performance Thin-Layer Chromatography (HPTLC) and Gas Chromatography coupled to Mass Spectrometry (GC–MS). These techniques were used to detect metabolic classes and/or groups, and to identify, for the first time, thirteen simple phenolic acids in this by-product. The sample antioxidant capacity was determined by methods of 2,2-diphenyl-1-picrylhydrazyl (DPPH)and 2,2′-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid) diammonium salt (ABTS⁺) radicals direct sequestration. The hydrolyzed fraction showed a total of 63.47% in the relative abundance of the total of compounds, standing out: p-hydroxybenzoic acid (39.19%) and protocatechuic acid (3,4-dihydroxybenzoic acid) (5.62%), both from hydroxybenzoic acids and 3-(3,4-dihydroxyphenyl)lactic acid, (7.76%) hydroxycinnamic acids derivatives. In these results, the fraction rich in simple phenolic acids was obtained, attributing the prominent behavior of this matrix antioxidant activity, expressed by (IC₅₀: of 16.42 µg/mL and 6.52 µg/mL for DPPH and ABTS⁺ radicals, respectively). The research demonstrated an alternative to applicability that involves sustainability from agro-industrial. These techniques were used to detect metabolic classes and/or groups, and to identify, for the first time, thirteen simple phenolic acids in this by-product, generating a process capable of converting biomass into a bioproduct, consisting of bioactive compounds, in addition to adding value to the industrial chain.     

简易多路气体分流装置在有机实验教学中的应用

介绍了一种简易多路气体分流装置,可以简单方便地将惰性气体分流供应多个学生同时使用,并确保每条支路气流量充足。该套装置可以提高操作的安全性同时减少资源的浪费,它拆装方便,可以在不使用时进行存放储藏,有效地减小占有空间。     

Electrochemical sensors for environmental gas analysis

The application of electrochemical sensors for measurement of concentration of pollutant gases in air in the part-per-billion (10⁹) range is reviewed. Performance-limiting factors, particularly the effects of extremes and of relatively rapid changes in ambient temperature and humidity, are noted. Variations in composition of the electrolyte in the meniscus at the electrode–gas interface and instability of the solid–liquid–gas contact line, causing important variations in current due to background electrode reactions, are deduced and suggested as the reason for the performance limitations. Suggestions are made for mitigation through instrument design.     

Modified layered bimetallic compound used as a novel adsorbent for the solid-phase extraction of monoaromatic hydrocarbons from water samples prior to gas chromatography–mass spectrometry

This study reports a promising method of solid-phase extraction for determining the toluene, ethylbenzene, p-xylene, m-xylene, o-xylene, 1,3,5-trimethylbenzene, and 1,2,4-trimethylbenzene in water samples by gas chromatography–mass spectrometry (GC–MS). Prior to this procedure, the magnesium–aluminum bimetallic hydroxides modified with sodium dodecylbenzenesulfonate (Mg/Al-SDBS-LDH) were prepared and served as the novel solid-phase extractant. The Mg/Al-SDBS-LDH has advantage of good hydrophobicity and larger spacing which facilitates the monoaromatic hydrocarbons (MAHCs) into the interlayer for adsorption. As a result, the seven MAHCs in 500 mL water samples were enriched greatly, and the theoretical enrichment factor reached to 125 times. Under the optimized conditions of solid-phase extraction (SPE) and GC–MS, the mass concentration of each MAHC (0.005–10, 0.01–10, or 0.05–10 ng/mL) had a fine linear relationship with peak area. The correlation coefficients were more than 0.995. The detection limits were between 0.001 and 0.01 ng/mL, and the RSD were between 3.1% and 6.6%. The method had been applied to determine the seven MAHCs in the Dongfengqu river water and laboratory wastewater of Chengdu University of Technology successfully.     

UPLC-Q/TOF-MS coupled with multivariate analysis for comparative analysis of metabolomic in Dendrobium nobile from different growth altitudes

Dendrobium nobile alkaloids (DNLA) and glycosides are the main active components extracted from Dendrobium nobile Lindl. (D. nobile) used for thousands of years in China. The pharmacological effects of the above chemical components are significantly different. D. nobile is mainly grown at an altitude ranging from 230 to 800 m in Chishui City, Northwest Guizhou Province. However, it is unclear whether the metabolite in D. nobile is influenced by the planting altitude. Hence, to reveal the different metabolite in D. nobile cultivated at the altitude of 336 m, 528 m, and 692 m, ultra-high performance liquid chromatography with Q/TOF-MS couple with multivariate analysis were developed. Using the orthogonal partial least squares-discriminant analysis, 19 different metabolites were discovered and then tentatively assigned their structures as alkaloids and glycosides by comparing mass spectrometry data with in-house database and literature. Moreover, the result of semiquantitative analysis showed the content of dendrobine that was belonged to alkaloids significantly increased at the altitude of 692 m, whereas the content of glycosides demonstrated an accumulation trend at the altitude of 528 m. The results could provide valuable information for the optimal clinical drug therapeutics and provide a reference for quality control.     

Remarkably large remote-stereocenter-induced chromatographic differences: azulenyl 1,5-diols

A series of four new azulene-1,5-diol diastereomers were prepared and found to exhibit large differences (ΔR_f 0.22–0.46) in silica TLC mobilities despite having stereocenters four bonds apart. The stereoisomers were identified by X-ray crystallography, and in all cases the RR/SS diastereomers were less strongly retained than the RS/SR diastereomers. The crystal structures suggested that this is due to a conformational preference for the CF₃ groups to be nearly perpendicular to the plane of the azulene ring, which caused the dihedral angle between the OH groups to be larger (in the RR/SS diastereomers) or smaller (in the RS/SR diastereomers). The smaller dihedral angles allow the RS/SR diastereomers to simultaneously bind to a silica surface and thus be more strongly retained. Two similar benzene derivatives and several cycloalkanediols with more proximate stereocenters showed little or no difference in mobilities between diastereomers, though the NMR differences were greater. Thus, the azulene ring is an important factor in enforcing the conformational preferences, either through steric interactions with the 4/8 substituents (H or methyl) or its significant dipole moment, or both.     

Automated headspace solid‐phase microextraction and on‐fiber derivatization for the determination of clenbuterol in meat products by gas chromatography coupled to mass spectrometry

A method was developed for the determination of clenbuterol in meat using stable‐isotope‐dilution gas chromatography with mass spectrometry coupled with solid‐phase microextraction and on‐fiber derivatization. The samples were first homogenized with hydrochloric acid followed by protein deposition. After headspace solid‐phase microextraction and on‐fiber derivatization, the content of clenbuterol was measured with the aid of stable‐isotope dilution. The condition of solid‐phase microextraction was optimized by central composite design. The relative standard deviations, limit of detection, and recoveries for clenbuterol were 4.2–9.2%, 0.48 μg/kg, and 96–104%, respectively. The proposed method was satisfactory for analysis of real samples as compared with the Chinese standard method.